182
{
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
{
If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
Examples
# Configure GigabitEthernet 1/0/1 as a trunk port, and assign it to VLAN 2, VLAN 4, and VLANs 50
through 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 2 4 50 to 100
Related commands
port link-type
port trunk pvid
Use
port trunk pvid
to configure the PVID for a trunk port.
Use
undo port trunk pvid
to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
vlan-id
: Specifies a VLAN by its ID in the range of 1 to 4094.
Usage guidelines
You can configure a nonexistent VLAN as the PVID of a trunk port. When you delete the PVID of a
trunk port by using the
undo vlan
command, the PVID setting of the port does not change.
For correct packet transmission, configure the same PVID for a local trunk port and its peer.
To enable a trunk port to transmit packets from its PVID, you must assign the trunk port to the PVID
by using the
port trunk permit vlan
command.
•
The configuration made in Layer 2 Ethernet interface view applies only to the port.
•
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface
and its aggregation member ports.
{
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
{
If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
Summary of Contents for FlexNetwork 5130 HI series
Page 302: ...294 ...
