93
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
When LACP is operating in passive mode on a local member port and its peer port, both ports cannot
send LACPDUs. When LACP is operating in active mode on either end of a link, both ports can send
LACPDUs.
This command takes effect only on member ports of dynamic aggregation groups.
Examples
# Configure LACP to operate in passive mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp mode passive
lacp period short
Use
lacp period short
to set the short LACP timeout interval (3 seconds) on an interface.
Use
undo lacp period
to restore the default.
Syntax
lacp period short
undo lacp period
Default
The LACP timeout interval is the long timeout interval (90 seconds) on an interface.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Examples
# Set the short LACP timeout interval (3 seconds) on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp period short
lacp system-priority
Use
lacp
system
-
priority
to set the system LACP priority.
Use
undo
lacp
system-priority
to restore the default.
Syntax
lacp
system-priority
system-priority
undo
lacp
system-priority
Summary of Contents for FlexNetwork 5130 HI series
Page 302: ...294 ...
