HP FlexNetwork 5130 HI series, Command Reference Manual

Page: 51 / 306

43
Field Description
Maximum transmission unit MTU of the interface, which is always 1536 and cannot be configured
Physical: InLoopBack The physical type of the interface is inloopback.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average input rate during the last 300 seconds:
•
bytes/sec —Average number of bytes received per second.
•
bits/sec —Average number of bits received per second.
•
packets/sec —Average number of packets received per
second.
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average output rate over the last 300 seconds:
•
bytes/sec —Average number of bytes sent per second.
•
bits/sec —Average number of bits sent per second.
•
packets/sec —Average number of packets sent per second.
Input: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of incoming packets of the interface
and the number of dropped packets.
Output: 0 packets, 0 bytes, 0 drops
Total number and size (in bytes) of outgoing packets of the interface
and the number of dropped packets.
# Display brief information about interface Inloopback 0.
<Sysname> display interface inloopback 0 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
InLoop0 UP UP(s) --
# Display brief information about interface Inloopback 0, including the complete description of the
inloopback interface.
<Sysname> display interface inloopback 0 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
InLoop0 UP UP(s) --
Table 10 Command output
Field Description
Brief information on interfaces in
route mode
Brief information about the inloopback interface.
Link: ADM - administratively down;
Stby - standby
Explains the Link field values:
•
ADM —The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
•
Stby —The interface is a standby interface.
Protocol: (s) - spoofing
Explains the Protocol field value.
(s)
—Represents spoofing. If the data link layer protocol of an interface
is up, but the link is an on-demand link or is not present, the Protocol
field displays
UP(s)
. This attribute is typical of interface Null 0,
Inloopback 0, and loopback interfaces.
Interface Interface name.