Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-71
Description
Use the
retry stop-accounting
command to set the maximum number of
stop-accounting request transmission attempts.
Use the
undo retry stop-accounting
command to restore the default.
Related commands:
reset stop-accounting-buffer
,
hwtacacs scheme
,
display
stop-accounting-buffer
.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 50.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] retry stop-accounting 50
1.3.14 secondary accounting
Syntax
secondary accounting
ip-address
[
port-number
]
undo secondary accounting
View
HWTACACS scheme view
Parameters
ip-address
: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number
: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the
secondary accounting
command to specify the secondary HWTACACS
accounting server.
Use the
undo secondary accounting
command to remove the configuration.
Note that:
z
The IP addresses of the primary and secondary accounting servers cannot be the
same. Otherwise, the configuration fails.
z
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
z
If you configure the command for more than one time, the last configuration takes
effect.
z
You can remove an accounting server only when no active TCP connection for
sending accounting packets is using it.
