Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-26
View
Ethernet port view
Parameters
10
: Specifies the port rate as 10 Mbps.
100
: Specifies the port rate as 100 Mbps.
1000
: Specifies the port rate as 1,000 Mbps.
auto
: Specifies to determine the port rate through auto-negotiation.
Description
Use the
speed
command to configure Ethernet port data rate.
Use the
undo speed
command to restore Ethernet port data rate.
By default, Ethernet port data rate is automatically negotiated between peer Ethernet
ports.
Note that the
speed 1000
command is only applicable to Gigabit Ethernet ports.
Related commands:
duplex
.
Note:
You are recommended to configure the same rate and duplex mode for two
interconnected ports to avoid packet loss.
Examples
# Configure the port rate as 100 Mbps for port Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] speed 100
1.1.26 storm-constrain
Syntax
storm-constrain
{
broadcast
|
multicast
}
pps max-pps-values min-pps-values
undo storm-constrain
{
all
|
broadcast
|
multicast
}
View
Ethernet port view
