Command Manual – PoE
H3C S7500E Series Ethernet Switches
Chapter 1 PoE Configuration Commands
1-4
Parameters
interface-type interface-number
: Specifies an interface by its type and number.
Description
Use the
display poe interface
command to display the power information of the
specified interface.
If no interface is specified, the power information of all PoE interfaces is displayed.
Examples
# Display the power state of Ethernet 2/0/2.
<Sysname> display poe interface Ethernet 2/0/2
Port Power Enabled : enable
Port Power Priority : critical
Port Operating Status : on
Port IEEE Class : 0
Port Detection Status : delivering-power
Port Power Mode : signal
Port Current Power : 5400 mW
Port Average Power : 5490 mW
Port Peak Power : 6500 mW
Port Max Power : 15400 mW
Port Current : 108 mA
Port Voltage : 50.8 V
Port PD Description : IP Phone For Room 101
Table 1-2
Description on the fields of the
display poe interface ethernet
command
Field
Description
Port Power Enabled
PoE state: enabled/disabled
z
enable: PoE is enabled.
z
disable: PoE is disabled.
Port Power Priority
Power priority of the PoE interface:
z
critical (highest)
z
high
z
low
