Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Chapter 6 Routing Policy Configuration Commands
6-4
[Sysname] route-policy setcommunity permit node 16
[Sysname-route-policy] if-match as-path 8
[Sysname-route-policy] apply community no-export
6.1.4 apply cost
Syntax
apply cost
[
+
|
-
]
value
undo apply cost
View
Routing policy view
Parameters
+
: Increases cost value.
+
: Decreases cost value.
cost
: Specifies a cost from 0 to 4294967295.
Description
Use the
apply cost
command to set a cost for routing information.
Use the
undo apply cost
command to remove the clause configuration.
No cost is set for routing information by default.
Related commands:
if-match interface
,
if-match acl
,
if-match ip-prefix
,
if-match ip
next-hop
,
if-match cost
,
if-match tag
,
route-policy
,
apply ip-address next-hop
,
apply local-preference
,
apply origin
,
apply tag
.
Examples
# Create routing policy
policy1
with node 10, matching mode as permit. If a route
matches the outbound interface VLAN-interface 10, set the cost for the route to 120.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface vlan-interface 10
[Sysname-route-policy] apply cost 120
6.1.5 apply cost-type
Syntax
apply cost-type
{
external
|
internal
|
type-1
|
type
-
2
}
undo
apply cost-type
