Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 4 PIM Configuration Commands
4-11
4.1.13 c-rp holdtime
Syntax
c-rp holdtime
interval
undo c-rp holdtime
View
PIM view
Parameters
interval
: C-RP timeout in seconds, with an effective range of 1 to 65,535.
Description
Use the
c-rp holdtime
command to configure the global C-RP timeout time, namely the
length of time the BSR waits before it must receive a C-RP-Adv message.
Use the
undo c-rp holdtime
command to restore the system default.
By default, the C-RP timeout time is 150 seconds.
Because a non-BSR router refreshes its C-RP timeout time through BSR bootstrap
messages, to prevent loss of BSR bootstrap messages, make sure that the C-RP
timeout time is not smaller than the interval at which the BSR sends bootstrap
messages. The recommended C-RP timeout setting is 2.5 times the bootstrap interval
or longer.
Related commands:
c-rp
,
c-bsr interval
.
Examples
# Set the global C-RP timeout time to 200 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-rp holdtime 200
4.1.14 crp-policy
Syntax
crp-policy acl-number
undo crp-policy
View
PIM view