GRASS VALLEY IQUCP25, User Manual

Page: 62 / 338

62
Connecting to the Card’s Configuration Interface
Connecting to the Multiviewer SDC with RollCall for UCP - 3901 Card
Connecting to the Multiviewer SDC with RollCall for UCP - 3901 Card
The Multiviewer SDC consists of two configuration components to which you have to make
separate connections. By default, you connect with RollCall to the:
• UCP - 3901 card at the MANAGEMENT IP address, at port 2050 (default).
• Multiviewer SDC at the
SFP1
IP address, at port 2051.
To set the IP address of the card’s Ethernet interfaces, see Local control using the Densité
frame control panel to set the Card’s IP Addresses , on page 38.
PREREQUISITE: The Multiviewer SDC license must have been installed.
By changing a configuration parameter, you can access both configuration components at
the same IP address using a single network connection to the card. You will still use two
different port numbers to individually access the card’s two configuration components. See
also Figure 4-2 on page 53
.
Proceed as follows.
1 Set the UCP - 3901’s IP address for the
MANAGEMENT
,
SFP1
, and
SFP2
Ethernet port IP
addresses. See Local control using the Densité frame control panel to set the Card’s IP
Addresses , on page 38.
2 Click Connect to RollCall Network button in the main toolbar.
3 Using RollCall, connect to the UCP - 3901’s MANAGEMENT IP address, at port 2051.
IQUCP Card

Connecting to the Multiviewer SDC
with RollCall for UCP - 3901 Card , on
page 62
IQUCP25 /
IQUCP50 Card

Connecting to the Multiviewer SDC
with RollCall for IQUCP25 /
IQUCP50 Card , on page 65
Card model
Software Defined Core
Description Multiviewer Essence Processing