GRASS VALLEY IQUCP25, User Manual

Page: 32 / 338

32
UCP - 3901 Card Installation and Operation
Installation of the Optical Interface (option)
Figure 2 - 2: Densité-3 frame – rear panel installation
Step 1: To install the rear connector panel:
1 If a card is installed in the slot whose rear panel is being changed, remove it as
described above.
2 Remove the existing panel (either blank or belonging to an existing card that is being
changed) by releasing the captive screw(s) at the bottom.
3 Position the new panel and secure it in place with the captive screw(s) at the bottom.
Step 2: To install the UCP - 3901 Card:
Once a matching rear connector panel has been installed, install the UCP - 3901 card as
follows:
1 Open the front panel of the frame.
2 Slide the UCP
- 3901 card into the slot and push gently on the handle to seat the
connectors.
When using a double-slot-width rear panel, the card should be inserted into the right-
most of the two slots. Inserting the card into the wrong slot will not damage the card,
and will be flagged by the on-card status LED flashing red to indicate that there is no
connection to the rear panel.
3 Close the front panel of the frame.
Installation of the Optical Interface (option)
See Installing the SFP Ethernet Module , on page 335.
Rear Panel and Connectors
Images of Rear Panel Connectors
The rear panel is shown below, and its various inputs and outputs are described.