GRASS VALLEY IQUCP25, User Manual

Page: 144 / 338

144
Essence Processing SDC
Logging - System
Where N is the input or Ethernet port number . To identify SFP 1 / 2, see Rear Panel and Connectors on
page 32 .
TIMESYNC_N_CLOCK_ADDRESS=
When
card is synchronized to a network PTP
grandmaster clock, this shows the
PTP grandmaster
clock’s IP address.
TIMESYNC_N_REQUEST_INTERVAL
=
When
card is synchronized to a network PTP
grandmaster clock, this shows the
interval between
PTP message.
TIMESYNC_N_REFERENCE=
When
card is synchronized to a network PTP
grandmaster clock, this shows which Ethernet port is
being used to receive the PTP clock source
.
FAN_STATUS
For the UCP
- 3901 Card only.
Logs the card’s cooling fan health.
OK: The card’s fan is operating normally.
FAIL: The card’s fan is not spinning, or is spinning too
slowly, or the fan cable is disconnected. Urgent
maintenance procedures must be considered: If this
alarm has been raised, the fan on the UCP - 3901 card
may have to be replaced. See Cooling Fan
Operational Assessment on page 320.
DENSITE_CONTROLLER_STATUS
For the UCP
- 3901 Card only.
Reports the connection status of the Densité frame’s
controller card to the UCP - 3901 card.
OK: The UCP - 3901 card has successfully connected to
the Densité frame’s controller.
Not Connected: The UCP - 3901 card did not connect
to the Densité frame’s controller or the UCP - 3901
card has lost connection to the Densité frame’s
controller.
DENSITE_CONTROLLER_IP_ADDR
For the UCP
- 3901 Card only.
Reports the IP Address of the Densité frame’s
controller card. If the IP address is 0.0.0.0, then the
UCP - 3901 card has not yet received the IP address
from the frame’s controller.
DENSITE_FRAME_SLOT
For the UCP
- 3901 Card only.
This is the slot number in which the UCP - 3901 card is
located within the Densité Frame.
Log Field Parameter Description