GRASS VALLEY IQUCP25, User Manual

Page: 175 / 338

175
UCP - 3901
User Manual
Parameter Description
MADI IO Displays how input and output spigots are currently configured. See
Card Firmware/Software Version , below, for information on how to
change this.
Where Am I Causes the front-edge and rear panel LEDs to flash, allowing the card
to be easily identified.
Genlock Select Genlock type:
Network: use the network’s PTP clock. See Time Sync Configuration
on page 178 for further configuration settings.
External Reference: UCP-3901 only; use the reference signal found at
the REF connector on the card’s rear panel. See Rear Panel and
Connectors on page 32.
Chassis Reference A / B: use the reference signal supplied through
the IQ Modular frame’s references.
Freerun: card is using its own clock with no reference to any other
source.
GUID Displays the absolute unique identifier associated with the card.
Domain R uses domains to partition a network; only nodes on the
same domain can communicate with one another. A domain is
uniquely identified with a number and a friendly name/alias.
Set an ID as required, then press
Take
to confirm the change.
Interface
Configuration
Displays the IP address for each of the Ethernet interfaces.
Card Firmware /
Software Version
Each software version contains multiple firmware images. These allow
different spigot input/output and flow standard combinations to be
selected.
Select the required software from the
Software Version
pane, then
select the firmware which provides the required combination of
inputs, outputs and flow standards from the list displayed on the
Firmware pane. Note : Restore and Restart buttons are displayed
only when an item not currently installed is selected.
See
Setting Spigot Configuration on page 176, for more information.
Click
Take
to restart the card and implement any changes made.
See Upgrading the UCP - 3901 / IQUCP25 / IQUCP50’s SDC Application
on page 309 for how to change the SDC application.
Installed 25G /
50G Licensed
Options
Shows the currently installed licensed card options. See See
Installing
a License into a UCP - 3901 / IQUCP25 / IQUCP50 on page 314 for how to
install a license.
Reset to Defaults
on Restart
Enable checkbox to cause any existing details stored on the module,
other than network IP settings, to be cleared down prior to restarting
the module. See Setting Spigot Configuration , below, and Defaults on
page 243 for more information.