GRASS VALLEY IQUCP25, User Manual

Page: 101 / 338

101
UCP - 3901
User Manual
Ethernet Pages 1 and 2
Ethernet 1
and
Ethernet 2
pages configure the card’s high speed media ports.
Ethernet 1
is
identified as SFP1 and Ethernet 2 is identified as SFP2 on the card’s rear panel. See Rear
Panel and Connectors on page 32.
Media ports manage PTP, video, metadata, and audio streams, card configuration and
upgrade, as well as NMOS IS-04 and IS - 05 communications with the NMOS registry.
The Ethernet pages show details and status for each of the card’s high speed media
network interfaces. The UCP - 3901 / IQUCP25 / IQUCP50 defaults to use DHCP for Ethernet
port address negotiation, but this can be overridden and a static IP address can be specified
if required.
The Ethernet configuration for these ports can also be set through the frame’s control
panel. This is useful when the card is first installed in the frame, to make it quickly
operational. See Local control using the Densité frame control panel to set the Card’s IP
Addresses on page 38.
Only make changes to the Ethernet settings during off hours as any settings change will
take the card offline for up to 30 seconds.
See
Ethernet Gb on page 165 for information on the:
•
MANAGEMENT
Ethernet connector for the UCP - 3901.
• on-card Ethernet connector (IQUCP25 / IQUCP50).
Figure 6 - 11:
Ethernet 1 Page