Goldacres Super Cruiser G8, Operator'S Manual, Page: 90 / 210

86 - Chapter 8 - Operation G8 Super Cruiser Operator’s Manual MY19 - REV 0
Drive, in this position 1st - 6th gears are
available and will be selected by the ECM
when required. Overdrive gears 5th & 6th
will only be engaged when in ROAD
MODE.
Gear UP. Press to manually upshift one
gear at a time until top gear is selected
when the transmission is in Drive. The
SELECT display will show which gear range
has been selected, and the MONITOR
display will show which transmission gear is
currently engaged.
NOTE: The transmission will not shift
above the gear range selected. When Drive
(D) is selected the full range automatic
shifting is restored.
Gear DOWN. Press to manually downshift
the transmission one gear at a time until
1st gear is selected.
The SELECT display will show which
gear range has been selected and the
MONITOR display will show which
transmission gear is currently engaged.
NOTE: The transmission will not shift
above the gear range selected. When Drive
(D) is selected the full range automatic
shifting is restored.
When the engine is started, the
transmission will start in ROAD mode.
When the MODE button is pressed, the
transmission goes into SPRAY mode
and ‘2 MODE’ will be displayed in the
MONITOR Display.
In SPRAY mode,
the transmission starts in 2nd gear and
limits top gear to 5th for spraying speeds.
Pressing the MODE button again cycles
back to ROAD MODE. Now 6th gear will
be selectable to enable speeds up to the
machine’s maximum speed of 50 Km/h.
Transmission
The operator must wear the operator safety belt
at all times when seated in the cabin or when the
machine is in motion. To engage a gear from neutral,
first apply the foot service brake located to the right
of the steering column, then release the park brake
and press the ‘D’ button on the gear selector to
drive forward or ‘R’ to reverse.
SELECT DISPLAY
This LED Character shows which gear has been
selected by the operator. It will display D, R, or N or
a number reflecting the specific gear.
MONITOR DISPLAY
This LED character shows which transmission gear is
currently engaged. This includes P, R, N, and numerical
values for forward gears. This side typically does not
display D for Drive – it allows the operator to glance
down and see the specific gear they are currently
using.
BUTTON FUNCTIONS
Continued over page
Select
Display Monitor
Display
u u
Reverse gear.
Neutral; the gear selector must be in this
position for starting.