Goldacres Super Cruiser G8, Operator'S Manual, Page: 84 / 210

80 - Chapter 8 - Operation G8 Super Cruiser Operator’s Manual MY19 - REV 0
Side Console Switches - General
CRUISE CONTROL / RPM RAISE
Press switch forward to turn ON Cruise Control
function. Press this switch forward again will turn the
function OFF.
Press the bottom of this switch will turn ON the
RPM Raise, which will increase the engine RPM to
1500 RPM. Press the bottom of the switch again will
turn this function OFF.
BOOM RECIRC
By pressing this switch forward, will turn ON the
recirculation function. The spray pump must be on
and the suction from tank open. Pressing the bottom
of the switch will this function OFF.
SPRAY PUMP ON/OFF
Press switch forward to activate the spray pump.
When the pump is on the light on the arm rest will
be illuminated. The pump will remain operating until
the switch is returned to the SPRAY PUMP OFF
location. If dual product pumps are installed this
switch must be first turned on to activate the pump
circuit required.
PARK BRAKE ON/OFF
This switch must be in the ON (forward) position
before starting the engine. If not, pull the orange
slide lock and then press forward to turn the
function ‘ON’. Once the engine has started and
the foot service brake has been applied, pull the
orange slide lock back and press the bottom of the
switch to disengage the park brake. A drive gear
can now be selected. When stopping the machine,
the foot service brake needs to be applied to bring
the machine to a complete stop, and then the
transmission needs to be placed in ‘N’ before the
park brake switch can be put in the ‘ON’ position.
AUTOSTEER
By pressing switch down, the GPS resume wires
are activated. If a GPS steering unit is fitted, 12 volts
will be supplied to the GPS auxiliary connector pin
‘C’ each time this momentary switch is triggered.
This switch returns immediately to the centre OFF
position once the operator releases it.
CENTRE DIFF LOCK ON/OFF
This switch will engage the differential lock in the
transfer case and split the drive 50/50 to the front &
rear axles. When the differential lock is fully engaged,
the light in the switch will illuminate.
DIFF LOCK REAR ON/OFF
This switch will engage the differential lock in the
rear differential and give full drive to both rear
wheels. When engaged, the light in the switch will
illuminate.