Goldacres Super Cruiser G8, Operator'S Manual, Page: 8 / 210

4 - Chapter 2 - Safety G8 Super Cruiser Operator’s Manual MY19 - REV 0
• When draining fluids from the equipment use
appropriate, leak proof containers. Do not use
food or beverage containers because someone
may consume the contents by mistake.
• Any unauthorised modifications to this equipment
may affect its function and create a serious safety
risk.
• Keep clear of overhead obstructions – especially
power lines as contact can be fatal.
• Never attempt to clean parts, or nozzles, by
blowing with mouth.
• Never attempt to siphon chemicals, or substances,
by sucking.
• It is imperative that the vehicle manufacturer’s
specifications be checked and all instructions for
use when transporting, or towing, be adhered to at
all times.
• Care should be taken when transferring liquid
into the tank to ensure that the gross weight of
the equipment does not exceed the braking and
carrying capacity of the vehicle as specified by the
vehicle manufacturer.
NOTE: 1 Litre water = 1 Kg.
• Water weighs 1kg per litre, however conversion
factors must be used when spraying liquids
that are heavier or lighter than water. Example:
liquid nitrogen has a density of 1.28 kg/L and will
therefore be significantly heavier than water if the
tank is filled completely. The total weight of a tank
full of chemical, should not exceed that of a full
tank of water. Machine damage can result if the
machine is over weight. See filling instructions in
Chapter 8 ‘Operation’ for more information.
• Suitable care should be taken when driving the
vehicle. Consideration should be given to both the
carrying capacity of the vehicle and the gradient of
the terrain when determining the speed at which
the vehicle can be driven safely.
• Ensure that the maximum speed of the vehicle,
when loaded, is within the vehicle manufacturer’s
limitations.
• Ensure equipment is securely fastened or attached
to vehicle at all times.
• Never stand within the radius of the boom wings.
• Never work under any hydraulically raised boom.
Cautions
• When leaving the sprayer always isolate the
batteries by turning the isolator key off and
removing it.
• A supply of fresh water should be with the
equipment at all times.
• Water tanks are not designed for use with diesel
fuel or any flammable liquid.
• Do not use this machine in ambient temperatures
exceeding 40 degrees Celsius.
• Ensure that all bolts are tightened and secured
before operation.
• Always ensure that the boom is securely supported
when travelling.
• Standard centrifugal spray pump: Running the
pump dry will cause failure. Care should be not to
operate at speeds exceeding 4200 rpm.
• Optional diaphragm spray pump: Care should be
taken to never overfill with oil or operate at speeds
exceeding 540 rpm.
• Do not exceed the maximum spraying pressure of
8 Bar.
Dangers
• Check area to be sprayed for overhead powerlines.
Contact between the machine and powerlines
can result in serious injury or death. If there are
powerlines in the spray area, exercise extreme
caution when tilting boom wings.
• Do NOT walk on machine platform when near
power lines.
• NEVER start the engine when standing on the
ground. Only start the engine from the operator’s
seat, with the transmission in neutral. Possible injury
or death can occur by starting the machine through
other methods.
• Never exit the cabin while the machine is in
motion.
• Diesel engine exhaust fumes are harmful and can
cause severe sickness or death. If it is necessary to
run the engine in an enclosed area use an exhaust
pipe extension. If an exhaust pipe extension is
unavailable ensure that all doors are fully open and
the room is well ventilated.
Personal Protective Equipment
(PPE)
Always wear close fitting clothing and appropriate
safety equipment designed for the job at hand.
• Exposure to loud noise over an extended period
can cause permanent hearing impairment or loss.
Be active in the conservation of your hearing and
wear appropriate hearing protection at all times.
• Chemicals can be harmful to humans, appropriate
PPE should be used when handling chemicals.
Safety Information
Continued over page