Goldacres Super Cruiser G8, Operator'S Manual, Page: 81 / 210

Chapter 8 - Operation - 77 G8 Super Cruiser Operator’s Manual MY19 - REV 0
Hopper Drain Tap -
Photo looking up from
underneath the hopper
Chemical Induction Hopper
• Turn the hopper tank valve at the bottom of the
hopper ‘OFF’ by turning the yellow handle so that
it is horizontal.
• Turn the Induction hopper valve on the EZ
control Pressure Delivery station to ‘Bypass’.
Drain the hopper of any remaining liquid using the
hopper drain tap at the bottom of the hopper.
RINSING OUT THROUGH DRAIN
The hopper can be rinsed and the rinsate emptied
through the hopper drain ball valve rather than
transferred into the main spray tank.
To do this:
1. Ensure the fresh water filling supply pump system
is operating.
2. Open the hopper rinse valve on the top of the
hopper.
3. ‘OPEN’ the hopper tank ball valve at the bottom
of the hopper by turning up the yellow handle so
that it is vertical, removing the rinsate from the
hopper.
4. Open the hopper drain valve.
CAUTION: Spray pump should be turned off.
NOTE:
• Take proper safety precautions to avoid any
contact with rinsate when draining, as it may
contain chemical residue.
• Be mindful of where rinsate is deposited as it may
contain chemical residue.
• This procedure will not rinse the hose from the
bottom of the hopper to the main tank.