Goldacres Super Cruiser G8, Operator'S Manual, Page: 126 / 210

122 - Chapter 9 - Boom G8 Super Cruiser Operator’s Manual MY19 - REV 0
REVISIONS
REV
DESCRIPTION
DATE / INITIAL
ECN
A3
SHEET 1 OF 1
DRAWING NUMBER:
TITLE:
MATERIAL
:
DRAWN BY:
G8 MY17 Parts book - 48m
Boom Assembly2
NEALHARVEY
MODEL EDITED BY:
11/05/2016
THIS DRAWING REMAINS THE PROPERTY
OF GOLDACRES TRADING PTY LTD AND IS
SUBJECT OF COPYRIGHT
SURFACE FINISH: WEIGHT:
DRAWING EDITED BY:
12/07/2018
REV
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETRES
SHEET
1-3 MORANG CR. MITCHELL PARK.
VICTORIA 3355 AUSTRALIA
PH: 03 5342 6399
DEBURR AND BREAK
SHARP EDGES
NEALHARVEY
12/07/2018
DRAWING CHECKED BY:
KG
DO NOT SCALE DRAWING
UNLESS OTHERWISE SPECIFIED
0. ± 1 ANGULAR ± 0.50° 0.0 ± 0.5 0.00 ± 0.25
D
D
C
C
B
B
A
A
1 1
2 2
3 3
4 4
5 5
6 6
FIRST STAGE
SECOND STAGE
THIRD STAGE
BREAKAWAY END
Pivot B
PARALIFT
RIGHT SIDE
Pivot A
Pivot A
Pivot C
Pivot D
Above: Top view of boom & tilt angle adjustment.
Boom Adjustment - 48 m
Alignment - Tilt
The boom is divided up into three stages and a
breakaway end. These stages need to have their
alignment angles adjusted at each pivot area.
BEFORE YOU BEGIN
• Park the machine on a flat level surface, engage
the parking brake and chock the sprayer wheels.
• Start with the boom in the working (unfolded)
position.
NOTE: It is important that both wings are adjusted
the same. If one wing is adjusted further forward or
back than the other, the boom may not sit level.
TILT ANGLE ALIGNMENT PROCEDURE:
FIRST STAGE
• The first stage tilt angle is electronically controlled
by an adjustable sensor at pivot A.
1. Follow “Before you begin” instructions above
and then start the engine and make sure that all
persons and objects are clear of the booms.
2. Loosen, but do not remove the screws on the tilt
angle sensor (Phillips head screwdriver).
3. Slots in the sensor mounting tabs allow it to
swivel when the screws are loosened. Rotate it
in the same direction that the first stage needs
to adjust in. Aim for an angle 0.2° above the
horizontal ground plane.
4. Once the correct alignment has been obtained,
re-tighten the screws on the tilt angle sensor
(Phillips head screwdriver).
5. Shut down the engine.
30 mm
Continued over page
30 mm
30 mm