138
- Chapter 10 - Lubrication & Maintenance
G8 Super Cruiser Operator’s Manual MY19 - REV 0
Steering Toe In
Steering toe-in should be set to 0-5 mm. To check
this measurement follow these steps:
Park the machine on a flat level surface.
1. Apply the parking brake and remove the keys
from the ignition.
2. Measure up from the ground 900 mm on the
front of the steer tyre and mark.
3. Repeat for the rear of the steer tyre.
4. Measure between the front of the left and right
steer tyres at the mark previously made and
record.
5. Measure between the rear of the left and right
steer tyres at the mark and record.
6. The front measurement must be 0-5 mm less
than the rear measurement.
7.
To make an adjustment, loosen the tie rod lock
nuts and then loosen or tighten until the toe-in
measurement is correct. Re-tighten the lock nuts.
Above:
Measurement X should be 0-5 mm less than
measurement Y.
Camber
The wheel camber is a factory set parameter and
cannot be adjusted. At the time of manufacture the
wheel camber is set to +0.5
º
.
Steering Swivel Housing
The front axle has a steering swivel on both side and
on the top and bottom of these is a grease point,
these should be greased every 100 hours.
Inside the swivel, there is a universal joint and this
also needs grease at the same intervals as the
steering swivel.
Steering
D
E
F
C
B
A
3
2
1
5
C
D
4
6
7
8
A
B
790.37 Kg
00
-
-
-
-
-
DEBUR ALL EDGES
DRG. STANDARD
/PRACTICE
AS 1100
REV
26/10/2015
Drawing Checked:
FINISHED WEIGHT:
Approved
Surface Finish:
THIS DRAWING REMAINS THE PROPERTY
OF GOLDACRES TRADING PTY LTD AND IS
SUBJECT OF COPYRIGHT
UNTOL. DIMENSIONS
OPEN DIM ± 0.20
ONE DEC. PL. ± 0.10
TWO DEC. PL. ± 0.05
ANGULAR ± 0.50°
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE
IN MILLIMETRES
10/09/2014
DATE EDITED:
Material <not specified>
ECN NO.
NAME/DATE
CHANGE
REV NO
David
C.Turner
Front Axle Assembly, Super Cruiser, G8, 2015
GA4907105
1-3 MORANG CR
MITCHELL PARK 3352
PH: 03 53426399
FAX: 03 53426308
Drawn By:
Material:
DO NOT SCALE DRAWING
GOLDACRES
TITLE:
DWG NO.
SCALE:1:10
SHEET 1 OF 1
A3
4
3
2
1
X
Y
FRONT
Summary of Contents for Super Cruiser G8
