GE UR T60, Instruction Manual

Page: 161 / 724

GE Multilin T60 Transformer Protection System 5-23
5 SETTINGS 5.2 PRODUCT SETUP
5
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

DNP / IEC104 POINT LISTS

ANALOG INPUT / MME POINTS
Up to 256 analog input points can be configured for the DNP or IEC 60870-5-104 protocols. The analog point list is config-
ured by assigning an appropriate FlexAnalog parameter to each point. Refer to Appendix A:
FlexAnalog Parameters for the
full range of assignable parameters.
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first “Off” value. Since DNP /
IEC 60870-5-104 point lists must be in one continuous block, any points assigned after the first “Off” point
are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the T60 is restarted.
g) IEC 61850 PROTOCOL
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

IEC 61850 PROTOCOL

ANALOG INPUT / MME

POINTS
Point: 0
Off
Range: any FlexAnalog parameter
MESSAGE
Point: 1
Off
Range: any FlexAnalog parameter
↓
MESSAGE
Point: 255
Off
Range: any FlexAnalog parameter

IEC 61850 PROTOCOL


GSSE / GOOSE

CONFIGURATION
MESSAGE

SERVER

CONFIGURATION
MESSAGE

IEC 61850 LOGICAL

NODE NAME PREFIXES
MESSAGE

MMXU DEADBANDS

MESSAGE

GGIO1 STATUS

CONFIGURATION
MESSAGE

GGIO2 CONTROL

CONFIGURATION
MESSAGE

GGIO4 ANALOG

CONFIGURATION
MESSAGE

GGIO5 UINTEGER

CONFIGURATION
MESSAGE

REPORT CONTROL

CONFIGURATION
MESSAGE

XCBR

CONFIGURATION
MESSAGE

XSWI

CONFIGURATION
NOTE
NOTE