GE Multilin
T60 Transformer Protection System
3-47
3 HARDWARE
3.4 MANAGED ETHERNET SWITCH MODULES
3
2.4.
The following window is displayed. Select the
Use the Following IP Address
option and enter appropriate
IP
address
,
Subnet mask
, and
Default gateway
values. It may be necessary to contact your network administra-
tor for assistance.
2.5.
Save the settings by clicking the
OK
button.
2.6.
Click the
Close
button to exit the LAN properties window.
3.
Connect your PC to port 1 or port 2 of the Ethernet switch module (with an RJ-45 – CAT5 cable).
4.
Verify that the two LEDs beside the connected port turn green.
5.
After few seconds you should see your local area connection attempting to connect to the switch. Once connected,
check your IP address by going to bottom of your screen and right-clicking the Local Area Connection icon as shown
below.
&OLFNKHUHWRVHWXS,3
DGGUHVV
$&'5
Summary of Contents for UR T60
