Future Design MCT-CM, User Manual

Page: 70 / 247

MCT-CM
70
MCT Function Runtime Menu Location Description
Loop View View\Loop View loop PV, %Out, set loop manual output mode and
loop set point
NOTE: Without access to the loop view screen, the user
will be unable to set loop in manual mode and adjust its
output.
Chart View View\Chart view and set up real time trends for loops and monitors
All View View\Overview view loop PV, %Out, set loop set point, view monitor
points and view and enable or disable manual events
Alarm View View\Alarm
Notifications view and reset current alarms
current alarm status
NOTE: With the function disabled, the user will only be
able to access the alarm screen to reset an alarm when
the alarm occurs by pressing the flashing alarm icon.
If the alarm is latching and does not reset, the user will
be unable to return to the screen to try and clear the
alarm unless another alarm occurs to again display the
flashing alarm icon.
Alarm Log View\Alarm File view and email alarm history files
Digital IO View View\Digital view current digital input and output status
Security Settings Security
Notifications view/set security rights, view audit trails, user log on
view security and audit status
NOTE: If security is enabled, but system security is then
disabled through this item, the user will be unable to log
on. Default security (operator level) access will be used.
This allows audit trails to be active while hiding all user
security features.
With security menu disabled, audit trail files are
accessible via Log/USB File Utilities or temporarily re-
enable security menu to gain access to the audit files.
Automatic Program
Control/Recovery Program
Device\Settings\Recovery
Notifications
view, create, edit and run automatic ramp/soak programs
set power recovery mode
view program status
NOTE: When disabled, all program items and menus will
be removed from the runtime application. The user will
be unable to access or start programs via the interface.
Automatic Program G-Soak Program\Entry
Program\View\Soak ability to view/edit soak events for steps of an automatic
program
ability to view/edit soak limits for an automatic program
NOTE: If a program is loaded that has G-Soak events
programmed, the operator will be unable to view or
change the event status and soak limits.