MCT-CM
10
2 Installation
All MCT components are pre-loaded with all operating software and firmware before leaving the factory so they
are ready to install when you receive them. Before beginning installation, completely read through this section
as well as the following section (3 Wiring) to gain an understanding of the entire installation process. Consider
the installation carefully. Plan the power, signal and control wiring before installing the MCT. Also consider the
cabinet space, hardware dimensions, environmental conditions and use good wiring practices to minimize
problems that may occur due to electrical interference.
2.1 Enclosure Guidelines
The MCT must be installed correctly for reliable operation. The MCT controller is designed for installation within
a suitable enclosure. Do not install the MCT outside of an enclosure. Care must be taken when locating
components to ensure that AC power wiring, contactors, starters, relays and other sources of electrical
interference are properly located to minimize their impact on the MCT control system.
Particular note should be taken to the position of variable speed drives and switching power supplies. Their
input and load cables should be screened and properly grounded to a central equipment grounding point to
prevent radiated emissions from affecting MCT operation.
2.1.1
Locating the MCT Touch Screen Interface
It is recommended that the unit be mounted within the front panel of a steel enclosure, through an appropriately
sized opening. Proper enclosure depth is required to ensure that there is adequate spacing between the rear
of the interface and the front of any high voltage devices mounted in the enclosure when the enclosure door is
closed. It is required
that a minimum separation of 2” be maintained, so plan a depth to accommodate at least
4
” (102mm) behind the front of the panel.
WARNING:
•
To avoid potential electric shock and other hazards, all mounting and
wiring for the MCT must conform to the National Electric Code (NEC)
and other locally applicable codes.
•
Special expertise is required to install, wire, configure and operate the
MCT controller. Personnel without such expertise should not install,
wire or operate the MCT.
CAUTION:
•
Prevent metal fragments and pieces of wire from dropping inside the
housing of any MCT component. If necessary, place a cover over the
components during installation and wiring. Ingress of such fragments
and chips may cause a fire hazard, damage or malfunction of the
device.
•
Do not touch the connector pins of the SD card or communication
connectors of the MCT touch screen interface to prevent electrostatic
discharge from damaging internal components.
•
Locate the MCT and all related control components away from AC
power/motor wiring and sources of direct heat output such as
transformers, heaters or large capacity resistors.
Summary of Contents for MCT-CM
