Future Design MCT-CM, User Manual

Page: 218 / 247

MCT-CM
218
All remaining steps of the Program follow the same format and data structure as is represented for step
one above. Up to the following 2744 registers are used to contain the additional step data of the
Program as required for steps 2 through 99. Since few if any programs will contain the maximum of 99
steps, it is only necessary to write the step data for the number steps used in the Program.
Register Numbers: Modbus Addresses:
2056 (0x0808)
– 2083 (0x0823)
402057
– 402084
Program Step 2 Data Registers
2084 (0x0824)
– 2111 (0x083F)
402085
– 402112
Program Step 3 Data Registers
2112 (0x0840)
– 2139 (0x085B)
402113
– 402140
Program Step 4 Data Registers
2140 (0x085C)
– 2167 (0x0877)
402141
– 402168
Program Step 5 Data Registers
2168 (0x0878)
– 2195 (0x0893)
402169
– 402196
Program Step 6 Data Registers
2196 (0x0894)
– 2223 (0x08AF)
402197
– 402224
Program Step 7 Data Registers
2224 (0x08B0)
– 2251 (0x08CB)
402225
– 402252
Program Step 8 Data Registers
2252 (0x08CC)
– 2279 (0x08E7)
402253
– 402280
Program Step 9 Data Registers
----------------------------------------------------------------------------------------------
through
----------------------------------------------------------------------------------------------
4772 (0x12A4)
– 4799 (0x12BF)
404773
– 404800
Program Step 99 Data Registers
Notes:
*D W Specifies writable data.
*E1
Parameter
Value
Description
0 Autostart Off
1 Autostart by Date
2 Autostart by Day
*E2
See note *B10 in section A.1.2.1 for information on the range of this parameters.
*E3
See note *B11 in Section A.1.2.1 for information on the range of this parameters.
*E4
See note *B12 in Section A.1.2.1 for information on the range of this parameters.
*E5
These parameters contain data which represent up to ten ASCII characters in order to display the name
of the currently loaded (or operating) program in the MCT.
See note *B9 in section A.1.2.1 for information on the range of these parameters.