MCT-CM
11
Proper clearance must also be maintained above, below and on both sides of the interface to allow for heat
dissipation and to facilitate
mounting. A minimum of 2” is recommended. Note that additional space may be
required below and to the right of the interface (looking from rear of unit) to accommodate the communications
wiring depending upon the type of communication cables used.
2.2 Environmental Considerations
Do not subject the MCT touch screen interface to operating temperatures below 0°C (32°F) or above 50°C
(122°F). The operating temperature for the Control Module is limited from 0°C (32°F) to 55°C (131°F). Minimum
and maximum relative humidity levels are limited between 10% and 90%, non-condensing. The MCT touch
screen interface is to be used indoors only. The unit should not be installed where fast temperature variations
may occur as this can cause condensation of water vapor on the device.
MCT components should not be exposed to excessive dust, dirt, salt, direct sunlight or shock and vibration. Do
not operate the MCT controller in an area where chemicals or flammable gases are present. Permitted storage
temperature extremes for the MCT control system are limited to -10°C (14°F) and 60°C (140°F).
2.3 Mounting Dimensions
The quantities of certain components vary depending upon the application and options ordered. Make sure
that you have all components required for your application prior to installation. The 4.3” touch screen interface
is supplied with four mounting brackets and the 7” touch screen interface is supplied with six.
All brackets must be installed and properly tightened to insure the IP65 protective rating. Failure to install all
mounting brackets may also affect touch screen operation. DO NOT over tighten the mounting brackets. The
brackets should be tightened just enough to fully compress the gasket so that the bezel is parallel with the
mounting surface. The maximum torque used should be applied evenly on all sides and not exceed 1N-m (8.9
in lb) to prevent the LCD panel from flexing.
Top view
Bottom View
Mounting Clip Slot
Mounting Clip Installed in Slot
Summary of Contents for MCT-CM
