Future Design MCT-CM, User Manual

Page: 34 / 247

MCT-CM
34
In addition to the communication parameters, the function level of the control must be set to ‘FuLL’. This permits
the MCT control module to access the necessary data values within the loop control. If the function level is left
in the basic (bASC) mode, communication errors will result.
*Required C-Series R22 Controller Settings for Proper Communications:
•
Option function selection (OFS1): R485
•
Address assignment of digital COMM (Addr): 1-10 (subject to system design)
•
Baud rate of digital COMM (bAud): 9.6
•
Data bit count of digital COMM (dAtA): 8bit
•
Parity bit of digital COMM (PAri): none
•
Stop bit count of digital COMM (StoP): 1bit
*See section 1-7 Menu Flowchart, in the C-
Series User Manual for instructions on accessing the control’s Setup
Menu and setting the above parameters as required.
*Required FDC 300 Series Controller Settings for Proper Communications:
•
Function complexity level (FunC): FuLL
•
Communication interface type (Conn): 485
•
COMM protocol selection (Prot): rtu
•
Address assignment of digital COMM (Addr): 1-10 (subject to system design)
•
Baud rate of digital COMM (bAud): 9.6
•
Data bit count of digital COMM (dAtA): 8bit
•
Parity bit of digital COMM (PAri): none
•
Stop bit count of digital COMM (StoP): 1bit
*See section 1-5 Menu Overview, in the 300 Series User Manual for instructions on accessing the
control’s
Setup Menu and setting the above parameters as required.