Future Design MCT-CM, User Manual

Page: 186 / 247

MCT-CM
186
11.1.2 Using the Web Server
The MCT
web server allows a user to remotely monitor operations anywhere via a PC’s standard web browser.
When enabled, the web server provides a detailed status page of the current operating conditions. The web
server can be enabled and disabled by pressing the web server (Www.) button on the communications screen
(select “Comms” from the Device\Settings\Set menu).
You must use the assigned IP address to access the MCT. The IP address is shown on the communications
screen and is also included in the notifications list. Write down the IP address so you will have it later to enter
into your web browser.
NOTE: Contact your network administrator prior to enabling the web server of the MCT. Company policy may
prohibit the use of web servers for security reasons. Future Design Controls is not responsible for the
use of, nor makes any claims as to the security of the web server interface over your network. The use
of the web server is the responsibility of the end user.
To access and view the MCT
web page, enter the following link in your PC’s browser address window:
http://”IPaddress”/mct.html
From the example address shown on the screen above, then entry would be:
http://192.168.0.6/mct.html . The following example is typical of the MCT web page appearance. The web page
updates automatically every 30 seconds and provides information on each individual control loop, ramp/soak
program status, alarm status and system event status.