FujiFilm Frontier-S DX100, Service Manual

Page: 57 / 303

57
3.3Troubleshooting by Error Message
DX100 Service Manual
Table 3-4. Error
Error
ID
Name Message Cause (Status) Remedy
E-2101
Tube maintenance error Parts have reached the end of their service life.
• Ink Supply Tube
Contact a technical representative.
Delete all print jobs remaining in the operating system's print
queue.
The replacement time of Ink Tube is near. 1. Replace the Ink Tube with a new one. (P. 116,
P. 186, P. 179)
2. Reset the counter of the Ink Tube. (P. 219)
E-2102
Decompression Pump maintenance error Parts have reached the end of their service life.
• Ink Supply Decompression Pump
Contact a technical representative.
Delete all print jobs remaining in the operating system's print
queue.
The Decompression Pump Unit has reached its end
of life. 1. Replace the Decompression Pump Unit with a
new one. (P. 181)
2. Reset the counter of the Decompression Pump
Unit. (P. 219)
E-2103
Passage Pump maintenance error Parts have reached the end of their service life.
• Ink Supply Pump
Contact a technical representative.
Delete all print jobs remaining in the operating system's print
queue.
Ink Passage Pump Unit has reached its end of life. 1. Replace the Ink Cartridge Holder with a new
one. (P. 175, P. 179)
2. Reset the counter of the Ink Cartridge Holder.
(P. 219)
E-2104
Suction Pump maintenance error Parts have reached the end of their service life.
• Ink Suction Pump
Contact a technical representative.
Delete all print jobs remaining in the operating system's print
queue.
Ink Suction Pump Unit has reached its end of life. 1. Replace the Capping Unit with a new one.
(P. 182)
2. Reset the counter of the Capping Unit. (P. 219)
E-5101
Communication error (USB) The printer is disconnected.
Delete all print jobs remaining in the operating system's print
queue.
Check that the cable is connected, and then turn the printer back
on.
Contact service support if the error continues to occur. • The printer and the PC cannot communicate.
• The system error occurs. 1. Connect the USB cable that connects printer
and PC again.
2. Identify the error code referring to "Diagnosing
failures based on the error code" (p47) .
3. Perform the remedy corresponding to the
identified error.
E-9901
Fatal error A printer system error occurred.
Delete all print jobs remaining in the operating system's print
queue.
Turn the printer off. Check if there is any paper remaining inside
the printer, and then turn the printer back on.
Contact service support if the error continues to occur. The system error occurs. 1. Reboot the printer.
2. Identify the error code referring to
"Diagnosing
failures based on the error code" (p47) .
3. Perform the remedy corresponding to the
identified error.