FujiFilm Frontier-S DX100, Service Manual

Page: 186 / 303

186
4.5Disassembly and Assembly Procedure
DX100 Service Manual
4.5.7.6 Left Ink Tube
1. Remove the Left IC Holder Cover. (P.98)
2. Remove the Top Cover. (P.97)
3. Remove the Upper Cover. (P.100)
4. Remove the Rear Frame. (P.101)
5. Remove the Left Frame. (P.102)
6. Remove the Left Ink Cartridge Holder. (P.175)
7. Remove the Left Heater Duct.
(
"4.5.8.3 Left Heater Duct/Right Heater Duct" Step10 (p190) )
8. Release the Left Ink Tube from the two clamps.
9. Remove the Ink Left Ink Tube and the O-ring from the Tube Joint.
(
"4.5.7.1 Ink Tube Joint" Step9 (p174), Step 11 (p174) )
Figure 4-152. Removing the Left Ink Tube
C A U T I O N
When the ink tube is removed at the following step, ink may drip
off from the tube. Prepare a waste cloth or the like in advance and
be careful not to contaminate the surroundings.

Tighten the screw that secures the
ink tube
with tightening torque
about 0.29N/m. (See Figure 4-134, Figure 4-141 )

Before installing the
ink tube
make sure the O-ring is attached to it.
Left Ink Tube
Clamp
Clamp