FujiFilm Frontier-S DX100, Service Manual

Page: 175 / 303

175
4.5Disassembly and Assembly Procedure
DX100 Service Manual
4.5.7.2 Left Ink Cartridge Holder
1. Remove the Left IC Holder Cover. (P.98)
2. Remove the Top Cover. (P.97)
3. Remove the Upper Cover. (P.100)
4. Remove the Rear Frame. (P.101)
5. Remove the Left Frame. (P.102)
6. Remove the heater upper cover.
(
"4.5.8.3 Left Heater Duct/Right Heater Duct" Step5 (p189) )
7. Remove the heater lower cover.
(
"4.5.8.3 Left Heater Duct/Right Heater Duct" Step6 (p189) to Step 7 (p189) )
8. Remove the CR frame cover.
(
"4.5.4.1 Self Sealing Valve" Step7 (p116) to Step 8 (p116) )
9. Remove the Tube fixing plate.
(
"4.5.4.1 Self Sealing Valve" Step9 (p117) to Step 10 (p117) )
10. Disconnect the cable of the decompression pump from the connector (CN202) of the
Main Board.
Figure 4-136. Releasing the cable (1)
11. Release the cable of the decompression pump from the three clamps and wire saddle.
12. Disconnect the cable from the connector of the decompression pump sensor.
13. Disconnect the cable from the three Ink end sensors.
14. Remove the connector of the cable of the Heater Unit.
15. Release the cable of the Heater Unit from two hooks of the Left Ink Cartridge Holder.
16. Release the cables and tube of the decompression pump from the two clamps.
17. Release the Left Ink Tube from the two clamps.
Figure 4-137. Releasing the cable (2)
Main Board
CN202
Cable of the
Decompression Pump
Left Ink Cartridge Holder
Wire saddle
Clamps
( Step 11 )
Ink end sensors
Left Ink Tube
Cable of the Heater
Unit and the tube of the
decompression pump
Connector of the
Decompression pump
sensor
Cable of the
Heater Unit
Connector
Clamp
( Step 11 )
Clamps
( Step 16 )
Clamps
( Step 17 )
Hooks
Cable of the
Heater Unit
Hooks