FujiFilm Frontier-S DX100, Service Manual

Page: 215 / 303

215
5.1General Overview
DX100 Service Manual
Adjustment Cartridge Related Head ID Input Register the head ID to the printer using the Service Program and check the currently registered
value. head ID is the ID to drive the Print Head with the proper voltage and correct the amount of
ink droplets. The ID is assigned to each head and listed on the label on the head.
Yes No P. 230
Head Incline Adjustment Prints an adjustment pattern to check if the Head Unit is slanted in the CR direction and corrects
the head angle.
Yes Yes P. 231
Bi-d Adjustment Adjusts the print start position between the outward and the return paths in bidirectional
printing.
Yes Yes P. 233
PG Adjustment (Mecha) Check if the platen gaps (distance between the CR Unit and the platen) are within the standard
value on the right and left side of the CR Unit using the thickness gauge. Check the two points on
the platen; Home side and Full side. If they are not within the standard value, adjust the height.
Yes Yes P. 234
Image Quality Adjustment By printing while correcting the print setting value (the amount of discharged ink per shot),
achieves both print quality (to reduce banding) according to the paper type and print resolution,
and higher speed printing.
Yes Yes P. 238
Release Carriage Lock Unlock the carriage.
Yes No P. 242
Color Calibration Adjustment Adjust the amount of ink droplets responding to the characteristics of the Print Head and the
electrical characteristics (dependent to the Main Board and the Power Supply Board) which
differ depending on the printer. Use the dedicated software and the Color Measurement Device
for this adjustment. Measure the print pattern with the Color Measurement Device, create the
correction value from the result, and then write the value to the NVRAM. The printer reads the
correction value to correct the amount of ink droplets.
Yes Yes P. 243
Release Driven Pulley ASSY Gap Adjustment Adjusts the tension of the CR timing belt.
No Yes P. 259
CR Scale Gear Position Adjustment Align the phases of the PG cams with the adjacent gear to maintain the degree of parallelism of
the carriage.
No Yes P. 259
Table 5-4. Adjustment Items
Class Adjustment Items General Overview
Tool*
Page
SP MECH