FujiFilm Frontier-S DX100, Service Manual

Page: 243 / 303

243
5.4Carriage Related Adjustment
DX100 Service Manual
5.4.7 Color Calibration Adjustment
You can perform calibration by using the following work flow.
5.4.7.1 Print a correction chart
1. Select 1. Adjust / Maintenance

Adjustment

Color Calibration
Adjustment .
2. Click [Run] to display the Select Printer screen.
3. Click [Renew the list] .
4. Select the M/C No. to be adjusted, and click [OK] .
Figure 5-42. Color Calibration Adjustment screen
Figure 5-43. Select Printer screen
C H E C K
P O I N T

You need a color measurement device to perform calibration. The
following models are supported.
 The “i1/i1Pro/i1Pro2” from X-Rite
 The “i1Sis” from X-Rite

When using a color measurement device, install the software for the
measurement device in advance on the PC.

Do not touch the printable side of the correction chart or the
verification chart. Moisture and oils from your hands can affect the
color measurement results.
Table 5-7. Calibration work flow
Item Description Reference
Print a correction chart Prints a chart for adjustment. P. 243
Correction chart color
measurement Perform color measurement for the printed chart on the PC
with a connected color measurement device. P. 251
Create correction value Create a correction value file. P. 256
Retaining sample correction
charts Retain three sheets of sample correction chart. P. 257
Checking the correction
value Check the written correction value. P. 258