FujiFilm Frontier-S DX100, Service Manual

Page: 251 / 303

251
5.4Carriage Related Adjustment
DX100 Service Manual
5.4.7.2 Correction chart color measurement

For the i1/i1Pro/i1Pro2
1. Confirm that the M/C No. displayed on the main screen and the M/C No. written
on the correction charts are the same.
Figure 5-60. M/C No.
2. Make sure the color measurement device is connected with the PC and its power is
on.
3. Place the color measurement device on the calibration base plate.
Figure 5-61. Color measurement device
4. Click [Measure Calib Chart] . (See Figure 5-46 )
5. When the confirmation screen appears, click [Yes] .
Figure 5-62. Confirmation screen
6. Place the correction chart that matches the color chart ID and preset ID displayed
on the screen on the measurement backup board supplied with the color
measurement device.
C H E C K
P O I N T
The procedure varies depending on the color measurement device you use.

i1/i1Pro/i1Pro2

Go to "For the i1/i1Pro/i1Pro2 (p251)" .

1iSis

Go to "For the i1iSis (p254)" .
C H E C K
P O I N T
Place the chart on white paper if there is no backup board available for
measurement.
M/C No.
M/C No.
C H E C K
P O I N T
Place the chart on white paper if there is no backup board available for
measurement.
Color measurement device