FujiFilm Frontier-S DX100, Service Manual

Page: 276 / 303

276
5.7Other adjustments
DX100 Service Manual

Print Head
1. Unlock the carriage lock. ( P. 242 )
2. Visually check from the side of the CR Unit if no foreign object is attached on the
Print Head surface. (See
Figure 5-101 )
3. Wipe off the foreign object with a dustless wipe if any.
Figure 5-101. Checking Method No.1 (2)

No.2
1. Remove the Top Cover. (P. 97)
2. Remove the Upper Cover. (P. 100)
3. Remove the Rear Frame. (P. 101)
4. Remove the Left Frame. (P. 102)
5. Measure the resistance between the white harness and black harness on the AID
Board. (See
Figure 5-102 )
6. Replace the AID Unit when the measured value is less than 1 M

. ( P. 113 )
7. Replace the Print Head if the value is still less than 1 M

after Step 6 . ( P. 120 )
Figure 5-102. Checking Method No.2
C H E C K
P O I N T

Remove the Capping Unit before removing the foreign objects on the
Print Head. (
P. 120 )

Be careful not to damage the Print Head surface.
CR Unit
Side view
Head surface
C H E C K
P O I N T
For routing the cable, see "4.6 Routing the cables and FFCs" (p202) .
Black harness
White harness
AID Board
Bottom side