FujiFilm Frontier-S DX100, Service Manual

Page: 42 / 303

42
2.2 Operation Sequence
DX100 Service Manual
Figure 2-15. Power On Sequence (6)
E
No
Yes
Ink consumption counter C: 0
Yes
治具モー ド か ?

After evaporation, waste ink
protection counter A is 0.

Waste ink counter SA is 0.
E-1
Yes
Initial charge
Check if an error occurred.

Waste ink over

CSIC error

Ink end
Yes
E-1 No
Checks if specified cleaning
conditions are met.
No
Before processing job, cleaning
flag is set.
No
Set the cleaning parameters given.
Check if an error occurred.

Waste ink over

CSIC error

Ink end
Yes
E-1 No
E-1
Check if roll set sensor detected
the paper.
Roll paper replacement flag: 1
F-3
No
Checks if the leading edge of paper
is at the start of feeding position.
Yes
No
F-2
Yes
Checks if RE (roll paper end
detection) sensor is on.
No
Yes
Roll motor rotation: CCW
PF motor rotation: CCW
Roll motor rotation: CCW
PF motor stop
E-2
PF motor rotation: CW
Roll motor rotation: CW
PF motor stop
E-2
Moves to the specified APG
position.
Move to the APG position PG+
Skew correction sequence
No
Yes
Check if roll paper replacement
flag is 0.
No
Yes
Detects roll paper width.
Roll paper replacement flag: 0
Initial cut
F-4
Check if initial cut counter is
greater than 43,200 sec.
No
F-1
F
Check if initial charge counter is 0.
Cleaning
PF synchronized normal rotation
Checks if it is called by print start.
PF synchronized normal rotation
Check if Jig mode.
E-3
E-3
No
Yes
PF synchronized normal rotation