FujiFilm Frontier-S DX100, Service Manual

Page: 123 / 303

123
4.5Disassembly and Assembly Procedure
DX100 Service Manual
4.5.4.4 CR Scale
1. Remove the Top Cover. (P.97)
2. Remove the Upper Cover. (P.100)
3. Remove the Rear Frame. (P.101)
4. Move the CR Unit to the center.
5. Remove the torsion spring from CR Scale.
6. Disengage the CR Scale from the hook of the frame at left side of the printer, and Pull
out the CR Scale slowly from the CR Unit.
7. Pull out the CR Scale slowly from the slit of the carriage assembly, and then turn the
scale 90 degrees upward and remove it from the hook of the frame.
Figure 4-51. Removing the CR Scale
C A U T I O N

Take care not to bend the CR Scale when removing/installing it
because it is fragile.

When handling the CR Scale, make sure to hold the scale only by the
edges taking care not to touch the scale surface.

Never touch the scale surfaces. Be extremely careful not to
contaminate or scratch the scale surfaces.

Attach the CR Scale so that its notched portion facing upward. (See
Figure 4-51 )

Make sure not to let the CR Scale touches the CR Unit when inserting
the CR Scale into the slit of the CR Unit.
CR Unit
Slit
Hook
Left
Torsion spring
Right
Hook
Chipped portion
CR Scale
CR Unit