FujiFilm Frontier-S DX100, Service Manual

Page: 133 / 303

133
4.5Disassembly and Assembly Procedure
DX100 Service Manual

Replacement procedure
1. Insert two tabs of the slide rail assembly jig (for roll unit) to the positioning holes of
the Roll Unit.
Figure 4-62. Attaching the slide rail assembly jig (for roll unit)
2. Set the Intermediate Slide Rail on the slide rail assembly jig (for roll unit).
Figure 4-63. Attaching the Intermediate Slide Rail (1)
3. Install the Intermediate Slide Rail to the Roll Unit in the following order.
1. Press down the Intermediate Slide Rail.
2. Pull the Intermediate Slide Rail in the front side direction.
3. Tighten three screws in the order shown in Figure 4-64 to fix the Intermediate Slide
Rail.
x
Slide rail assembly jig
(for roll unit)
Roll Unit
Left
Tab and positioning
hole
Tab and positioning
hole
Intermediate Slide Rail
Slide rail assembly jig
(for roll unit)
C H E C K
P O I N T
Since the screw holes on a new Roll Unit have no grooves, users may feel
resistance in tightening screws. However, this is not a failure.