FujiFilm Frontier-S DX100, Service Manual

Page: 238 / 303

238
5.4Carriage Related Adjustment
DX100 Service Manual
16. Loosen the two screws of the right parallel adjust bushings, Move the two right
parallel adjust bushings until the gap falls within the standard range.
Figure 5-35. PG Adjustment (Mecha) (4)
17. Remove the thickness gauge.
18. Move the CR Unit to the full side.
19. Perform the Step 7 to Step 8 . When the platen gap is within standard, go to Step
20 . When the platen gap is out of standard, perform Step 10 to Step 18 again.
20. Remove the thickness gauge.
21. Install the Upper Cover. (P. 100)
22. Install the Top Cover. (P. 97)
5.4.5 Image Quality Adjustment
1. Set the scanner on standby. (Refer to "7.1 Service Tool" (p297) for supported
scanners.)
2. Connect the scanner with the PC, and install the scanner driver on the computer.
3. Select 1. Adjust / Maintenance

Adjustment

Image Quality Adjustment .
4. Select the connected scanner.
5. Click [Print] to print the adjustment pattern. (See Figure 5-37 )
Figure 5-36. Image Quality Adjustment
6. Dry the adjustment pattern for about five minutes.
Bushing moving direction
The platen gap became widen.
The platen gap became narrower.
Right parallel adjust bushings
CR Unit
Front