Fuji Xerox DocuPrint M355 df, User Manual

Page: 275 / 428

Using the Operator Panel Menus and Keypad
275
• Adobe Protocol
Purpose:
To specify PostScript communication protocol. You can configure the
Adobe Protocol
settings for the wired
network. The change becomes effective after the printer is turned off and then on again.
Values:
System Settings
Use
System Settings
to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Power Saver Timer
Purpose:
To specify the time for transition to Power Saver mode.
Values:
Select
1min
(default) for
Low Power Timer
if your printer shares an electrical circuit with your room lights and you
notice them flickering. Otherwise, select a high value to keep your printer available for frequent use with the
minimum warm-up time.
The printer automatically returns to the standby mode from the Power Saver mode when it receives data from the
computer or remote fax machine. You can also change the status of the printer to the standby mode by pressing the
( Energy Saver ) button on the operator panel.
• Power Saver Wake Up
Purpose:
To specify whether to wake up from the Low Power or Sleep mode when
OnHook
is set to
Off
.
Values:
Auto Sets the PostScript communications protocol automatically.
Standard Sets the PostScript communications protocol to
Standard
.
BCP Sets the PostScript communications protocol to
BCP
.
TBCP* Sets the PostScript communications protocol to
TBCP
.
Binary Sets the PostScript communications protocol to
Binary
.
Low Power
Timer 1min
*
Specifies the time taken by the printer to enter Low Power mode after
it finishes a job.
1–60
Sleep Timer 1min
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–60
OffHook Wake Up Off
*
Does not wake up from the Low Power or Sleep mode when
OnHook
is set to
Off
.
On Wakes up from the Low Power or Sleep mode when
OnHook
is set to
Off
.