Flyer Goroc 3, Translation Of The Original Instruction Manual

Page: 198 / 252

45
EN
The brake lever may not be used when
your bicycle is lying sideways, upside
down or if a wheel has been removed.
Otherwise air bubbles can enter the hy-
draulic system which could cause the
brakes to fail. After transporting the bicy-
cle, check if the pressure point of the
brakes seems softer than before. Then
apply the brakes slowly several times.
This allows the braking system to dis-
charge any bubbles. If the pressure
point remains soft, please refrain from
riding. A FLYER specialist retailer must
discharge the air from the brake system.
You can avoid this problem by applying
the brake lever before transport and
then fixing it in this position using a
strap. This prevents any air from enter-
ing the hydraulic system. Please note
that the brake lever may not be pulled
when the wheel has been removed.
Place a spacer between the brake
blocks if you need to remove the wheel.
• Do not transport your e-bike upside
down. When securing the bike, en-
sure that no damage is caused to the
fork or the frame.
• You may not attach your e-bike to
the roof rack or rear carrier by its
crank set. The e-bike must always be
transported standing on its wheels.
Non-compliance may result in dam-
age to the e-bike.
When transporting the e-bike by car, the
battery must be removed and transport-
ed separately.
• Make sure that the battery’s contacts
are safe from short circuiting.
• The motor and electrical components
must be covered for transporting to
avoid any moisture penetration.
The driver is responsible for transport by car in
compliance with the applicable laws and regula-
tions. FLYER AG cannot be held liable in connec-
tion with the transportation of the FLYER on roof
or rear carriers.
Public transport
Obtain information regarding the local regulations
when you intend to transport your e-bike on public
transportation.
Aircraft
Obtain information regarding the legal guidelines
if you intend to transport your FLYER by aircraft.
Ask your airline.
resulting risks. FLYER E-MTBs are not allowed to
be ridden carrying a child seat.
Bicycle trailers and child trailers
Your FLYER e-MTB is not approved for use with
a trailer.
20.3 Roof and rear carrier on a car
Only use rear carriers which satisfy the ap-
plicable national legislation for transporting
your bike by car. The use of rear carriers
may lead to accidents. Transporting or fix -
ing the bike inappropriately could cause
damage to your car, mount or E-MTB.
• Adjust your driving according to the
weight of your rear carrier.
• When transporting your bike, you
should check regularly that your
FLYER e-bike is secure and safely
fastened.
• If your FLYER falls out of the carrier,
it can cause serious accidents.
• Avoid transporting your FLYER on the
roof of a vehicle and always cover the
motor with a rain protector cover to
prevent it from becoming damaged.
It is strongly recommended to cover
the whole bicycle with a rain protector
cover.
• Please note that loose parts, such as
tools, luggage and tool bags, child
seats, air pumps etc. could fall off dur -
ing transport. This may put other peo-
ple on the road at risk. All loose parts
should therefore be removed from the
FLYER before you start riding.
• A roof rack changes the total height of
your vehicle.
• Pay close attention to the maximal
load capacity if you transport your
bike on the roof of a vehicle.