Flyer Goroc 3, Translation Of The Original Instruction Manual

Page: 199 / 252

46
Always remove the battery before clean-
ing, maintaining or repairing your e-bike.
Ensure that you do not touch and thus
possibly connect contacts when clean-
ing or maintaining the battery. You risk
being hurt and the battery may suffer
damage if the contacts are live. Do not
use a high pressure water stream or a
high pressure cleaner on your bike. The
cleaning liquid may enter sealed bear-
ings due to high pressure, dilute the lu-
bricant and increase friction. As a result,
rust is formed which destroys the bear-
ings. Cleaning with a high-pressure
cleaner may damage the electrical sys-
tem.
4. When cleaning your FLYER
e-bike, you should never apply acids,
grease, oils, brake cleaners (with ex -
ception to the brake discs), and liq-
uids containing solvents.
These damage the surfaces and contrib-
ute to wear on the FLYER.
After use, ensure that you dispose of the
lubricant, cleaning and care products in
an environmentally friendly way. These
substances do not belong in domestic
waste, in the drain or in natural environ-
ments. Smooth operation and durability
of your FLYER e-bike depend on appro-
priate maintenance and care for your
FLYER.
• Regularly clean your FLYER with
warm water, small amounts of clean-
ing agent and a sponge.
• While cleaning the FLYER, always
check your e-bike for cracks, notches
or material deformities.
• Damaged parts must be changed with
original spare parts. Please only ride
your FLYER again after this check
has been carried out.
• Have possible paint damage removed
by your FLYER specialist retailer.
Further important information concerning care for
your FLYER e-bike is provided on the website of
your respective component manufacturer.
22. Wearing parts
Your FLYER is a technical product and therefore
requires regular inspection.
Depending on the function and despite the de-
gree of use, many parts on your FLYER are able
to show signs of wear and tear.
21. Electrical motor
All information, data and instructions concerning
the electrical system of your FLYER e-bike are
included in the attached operating instructions
for the electrical support system installed in your
FLYER. They include details of the operation and
maintenance, all important safety instructions
and information concerning the following compo-
nents:
• Operating element and display
• Battery and possible ranges
• Charger
• Drive unit
• Speed sensor and spoke magnet
Some general facts concerning the function and
range of your FLYER’s motor are listed below:
Function:
The motor starts working as soon as you start
pedalling when one of the support modes has
been selected. The performance of the motor de-
pends on several factors:
•
The power applied when pedalling
If you pedal with less power, you are provided
with less support than when you your increase
your pedalling power, i.e. when riding uphill.
However, this increases the power consumption
and decreases the range.
• Support mode
The higher the level of support, the more power
the motor will provide. However, high motor per-
formance means high power consumption. The
lowest support mode provides the least support
but also the longest range.
Range
Specified range information has been obtained
under optimal conditions. Ranges achieved un-
der everyday conditions will usually be shorter.
Please consider this when planning your route.
The range depends on many factors. These in-
clude battery capacity, motor support level select-
ed, geographical conditions, road surface, driving
style, environmental temperature, the weight of
the driver, tyre pressure and the technical state of
your FLYER e-bike.
Driving without drive support
You can also drive your FLYER without drive
support by selecting the «OFF» support mode.
Ensure that your system is always switched on.
Never drive without a battery or with your
system switched off, as the functions of
the operating unit and the lighting func-
tions are not available in this case.