6 Installation
6.3 Temperature probe
FLUXUS F60*
2017-10-16, UMFLUXUSF60xV5-0EN
44
• Use coupling foil or apply a layer of thermal conductivity paste or coupling compound
on the contact surface of the temperature probe. Observe the corresponding operating
temperature range.
• Observe that there must be no air pockets between the contact surface of the tempera-
ture probe and the pipe wall.
6.3.2
Installation of the temperature probe (response time 50 s)
Select the installation instructions according to the supplied clasp:
• for the installation with clasp, see section 6.3.2.1
• for the installation with FLEXIM clasp, see section 6.3.2.2
• for the installation with quick release clasp, see section 6.3.2.3
6.3.2.1
Installation with clasp
• Cut the tension strap to length (pipe circumf at least 120 mm).
• Make sure that part (2) of the clasp is on top of part (1), see Fig. 6.11 a. The hooks of
part (2) have to be on the outer side of the clasp.
• Pull approx. 20 mm of the tension strap through the slot of the clasp to fix the clasp to
the tension strap, see Fig. 6.11 b.
• Bend the end of the tension strap.
• Position the temperature probe on the pipe, see Fig. 6.12.
• Place the tension strap around the temperature probe and the pipe.
• Insert the tension strap through the parts (2) and (1) of the clasp.
• Tighten the tension strap and engage it in the inner hook of the clasp.
• Tighten the screw of the clasp.
Notice!
In case of great temperature differences, it is recommended to thermally insulate the
temperature probe from its environment.
Caution!
The edge of the tension strap is very sharp.
Risk of injury!
→
Debur sharp edges.
→
Wear the required personal protective equipment. Observe the appli-
cable rules.