Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 72 / 112

71
7. Repeat Steps 1-6 to install the second
casing on the other freezer/barrel to hold
the Blending Assembly’s 9-Tube Assembly.
8. Repeat Steps 1-6 to install the third Casing
Assembly next to the Touchscreen, near the
top of the freezer to channel the
Touchscreen electrical cable to the back of
the unit. Tuck the any hanging cables
behind the edge of the casing so that they
are not in the way.
NOTE: CABLE CLIPS MAY BE USED TO
SECURE THESE CABLES SO THAT THEY
DO NOT INTERFERE WITH THE OPERATING
PARTS ON THE FRONT OF THE FREEZER.
NOTE:
IF THE TOUCHSCREEN CABLES
TEND TO BE ON THE OPPOSITE SIDE OF
WHERE THEY CONNECT TO THE
SWITCHES AND INJECTOR / BLENDING
ASSEMBLIES, WRAP THE TOUCHSCREEN
SWTICH AND MOTOR CABLES AROUND
THE BACK OF THE TOUCHSCREEN TO
HANG DOWN THE DRIVE MOTOR SIDE OF
THE FREEZER. THIS SHOULD HELP KEEP
THE DRAW HANDLE AREA CLEAR OF
HANGING CABLES. YOU MAY ALSO ASK AN
AUTHORIZED TECHNICIAN FROM YOUR
LOCAL DISTRIBUTOR TO CHANGE THE
PORTS INSIDE THE TOUCHSCREEN BOX.
Connecting the Unit Syrup Lines
The syrup line Lead
“A” at the lower back of the
cabinet connects the 4 bags of syrup in trays
#1-4 to the Injector Assembly and the soft serve
freezer. The syrup line Lead “B” connects the
remaining bags of syrup in trays #5-8 to the
Blending Assembly and the frozen beverage
freezer. An additional tube in each Lead
connects the Sanitizer Tank to the Injector and
Blending Assemblies. A 9-Tube Extension is
included to connect the Lead that is the furthest
from the corresponding Injector / Blending
Assembly.
1. Locate the 9-
Tube Leads labeled “A” and
“B” at the back of the cabinet. Lead “A” will
connect to the soft serve freezer; Lead
“B”
connects to the frozen beverage freezer. If
needed, the 9-Tube Extension provided can
be attached to one of the leads (typically
“B”) if one of the freezers is further away
from the cabinet. If you do not need an
extension (ie, both 9-Tube Assemblies
reach to the back of the cabinet), then skip
to Step 10.
2. Remove the dust cap of the Lead that will
require the Extension. Slide the coupler
casing toward the unit to expose the Lead
line coupler.