Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 69 / 112

68
(B) When installing on separate freezers, install
each 9-Tube Assembly on the side of the
freezer with the INTAKE vents, with the rest
of the Injector / Blending Assembly on the
opposite side. Typically, the intake vents are
on the right side on Taylor 430 models, and
left side for Taylor 428 models and Taylor
C708 models. If the 9-Tube Assembly is
installed on the side of the outtake vents,
the warm air could heat the syrup and melt
the base product upon serving. Installing
the 9-Tube Assembly on the intake vent
side keeps the product cool and consistent.
(C) When installing both the Injector and
Blending Assemblies on one multi-barrel
freezer, install each 9-Tube Assembly on
either side. If possible, the Drive Motors
should be towards the center of the freezer,
opposite the 9-Tube Assemblies as shown
in Position “A” above. But they can also be
installed to the outside of the freezer as
shown below.
Installing the Injector System and
Suspension Bracket
1. Determine how the Injector / Blending
Assembly will be positioned on the freezer.
Follow the recommended position outlined
above.
2. Assemble the Suspension Bracket and
install it onto the Gear Box on the side
closest to the operator. Ensure all parts are
assembled in the proper position. (See
Figure 136.)
NOTE: THE PLASTIC WASHER SHOULD
ALWAYS BE BETWEEN THE BRACKET
KNOB AND THE UPPER BRACKET.
NOTE: THE UPPER BRACKET SHOULD
ALWAYS BE INSTALLED TO THE OUTSIDE
OF THE BRACKET BASE.
NOTE: THE SPRING WASHER SHOULD BE
BETWEEN THE UPPER BRACKET AND THE
BRACKET BASE.
NOTE: THE BRACKET THUMB SCREW
SHOULD ALWAYS BE INSERTED THROUGH
THE UPPER BRACKET FIRST AND THEN
SCREWED INTO THE BRACKET BASE,
PLACING IT ON THE OUTSIDE OF THE
BRACKET ASSEMBLY.
NOTE: THE HOOK OF THE UPPER
BRACKET CAN BE FACING EITHER
DIRECTION ACCORDING TO PREFERENCE.