Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 83 / 112

82
Testing the TS 44SS/BEV System
Once the system is enabled to dispense flavors,
test each pump to ensure they all dispense
properly and that the Injector / Blending
Assembly operates correctly.
1. The Touchscreen should be programmed
with a list of menu flavors. If it is not, skip
ahead to the section ASSIGNING
FLAVORS TO THE MENU to set up the
flavor labels for your system. If the screen
has flavors listed different than the ones
currently in the containers, you may
proceed with these instructions first and
change the menu later.
2. Select Spout A.
3. If the screen shows serving sizes (Small,
Medium, Large, Extra Large), press and
dese
lect “Medium” so that
no sizes are
selected.
4. Select all four flavors on the screen.
5. Hold a large container under the spout.
Move the draw handle to the open position
to dispense product. Ensure the TS
44SS/BEV operates properly with all four
syrup lines dispensing in succession.
NOTE: IF THE SYSTEM SOUNDS A BEEP
AND FLAVORS CEASE TO FLOW, A
SERVING SIZE MAY HAVE ACCIDENTLY
BEEN SELECTED. REPEAT THESE STEPS,
PAYING PARTICULAR ATTENTION TO
STEP 3.
6. If a syrup line fails to operate when tested,
select that flavor on the Touchscreen and
draw the serving again to verify the syrup
pump is malfunctioning. See the
Troubleshooting section at
www.flavorburst.com or contact your local
distributor for help.
7. Repeat these instructions for Spout B to
verify the other four pumps are working
properly.