Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 55 / 112

54
5. Remove the o-rings and Injector / Blending
Head and place them on a sanitary tray to
dry.
6. Place the larger o-ring into the groove on
the underside of the Injector / Blending
Head.
7. Apply food-grade lube to the two syrup port
o-rings and then place them into their
respective places inside the syrup port. A
small tool may be used to ensure the
o-rings are fully seated in the grooves.
NOTE:
O-RINGS MUST BE COMPLETELY
SEATED TO PREVENT LEAKAGE.
Miscellaneous Cleaning Procedures
The following parts of the TS 44SS/BEV do not
require daily cleaning. Inspect these areas
periodically and clean if necessary according to
instructions.
Mix approved detergent with warm water
according to manufacturer’s instructions. Also
prepare approved sanitizer solution according
to manufacturer’s instructions.
NOTE: DO NOT USE AN EXCESSIVE
AMOUNT OF WATER OR DETERGENT IN
CLEANING THE OUTSIDE OR INSIDE OF
THE CABINET.
Area Under the Cabinet
1. Carefully move the cabinet to an area
outside of where it was sitting.
2. Clean the area using a single service towel
moistened with warm detergent water. Use
a brush if necessary.
3. Rinse area with a single service towel and
clean, warm water and then wipe dry with a
dry single service towel.
4. Clean the outside and underside of the
cabinet using detergent, water and single
service towels.
5. Carefully return the cabinet to its original
place.