Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 52 / 112

51
6. Once syrup flows consistently from the
Injector / Blending Head, press the flavor
key again to complete the procedure.
7. Repeat Steps 5-6 for the rest of Spout A
flavors.
8. When all the syrup lines from Spout A have
been primed, press the INJECTOR FLUSH
key to clean the Injector / Blending Head.
9. Press DONE to exit the Prime Syrup Pump
mode and return to the main screen.
10. Repeat these instructions to prime Spout
B’s syrup lines. Select Spout B options
instead of Spout A when available.
Refilling the Sanitizer Tank
The Sanitizer Tank system provides approved
sanitizer solution to specific areas of the Flavor
Burst
®
system such as the Injector / Blending
Head and syrup lines. In order to utilize these
clean-in-place functions, keep an adequate
supply of approved sanitizer solution in the
Sanitizer Tank at all times. The Sanitizer Tank
should be checked on a daily basis, but only
needs to be refilled if the supply is low.
1. Prepare approximately 3 gallons
(11.5 Liters) of approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the hand pump from the Sanitizer
Tank and discard any remaining sanitizer.
3. Fill the Sanitizer Tank with the solution.
4. Reinstall the hand pump and tighten. Pump
air into the Sanitizer Tank with the handle to
prime the pump (approximately 10 strokes.)
NOTE: NO PRESSURE IS NEEDED IN THE
TANK DURING NORMAL OPERATIONS.