Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 74 / 112

73
9. Slide the coupler casing over the connection
and screw each coupler nut into each end of
the casing. Tighten the coupler nuts to
secure the connection.
10. Remove the dust cap from a 9-Tube Lead
not using the Extension. Slide the coupler
casing toward the unit to expose the lead
line coupler.
11. Remove the 9-hole gasket from the
remaining 9-Tube Assembly and align the
gasket with the coupler pins of the Lead.
12. Align the coupler pins of the Lead with the
appropriate 9-Tube Assembly coupler pins
and connect the assemblies.
NOTE:
LEAD “A” MUST BE ATTACHED TO
THE 9-TUBE ASSEMBLY ASSOCIATED WITH
THE SOFT SERVE FREEZER
. LEAD “B”
MUST BE ATTACHED THE 9-TUBE
ASSEMBLY ASSOCIATED WITH THE
FROZEN BEVERAGE FREEZER. THE
TOUCHSCREEN IS DESIGNED TO OPERATE
CERTAIN PUMPS ASSOCIATED WITH EACH
LEAD; MIXING THESE LEADS WITH THE
WRONG 9-TUBE ASSEMBLIES WILL RESULT
IN FLAVORS PUMPING TO THE WRONG
FREEZER.
13. Slide the coupler casing over the connection
and screw each coupler nut into each end of
the casing. Tighten the coupler nuts to
secure the connection.
14. If no Extension was used, repeat Steps 10-
13 to connect the other Lead and 9-Tube
Assembly.