Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 4 / 112

3
Always follow these safety precautions when
operating the Flavor Burst
®
system:
DO NOT operate the system without
reading this operator’s manual. Failure to follow
this instruction may result in equipment
damage, poor system performance, health
hazards, or personal injury.
DO NOT operate the system unless it is
properly grounded. Failure to follow this
instruction may result in electrocution.
DO NOT operate the system with larger
fuses than specified on the system data label.
Failure to follow this instruction may result in
electrocution or damage to the machine.
Consult your electrician.
DO NOT put objects or fingers in the
door spout. Failure to follow this instruction may
result in contaminated product or personal
injury from blade contact.
The TS 44SS/BEV cabinet system must
be placed on a level surface capable of
supporting at least 220 lbs of weight. Failure to
comply may result in personal injury or
equipment damage.
DO NOT install the unit in an area where
a water jet could be used, and do not use a
water jet to clean or rinse the system. Failure to
follow these instructions may result in serious
electrical shock.
NOISE LEVEL: Airborne noise emission
does not exceed 70 dB(A) when measured at a
distance of 1.0 meter from the surface of the
machine and at a height of 1.6 meters from the
floor.
NOTE: Operations Manual subject to change.
Parts and part numbers may vary from what is
shown and listed. Contact your local distributor
for most recent updates concerning the unit.
NOTE: The components of both the Injector
and Blending Assemblies appear very similar,
but are specifically designed to work for either
soft serve or shake product. Ensure the
Injector Head INJ 422 (has one internal pin) is
installed with Gear Cartridge INJ 321 (no
screen) on the soft serve freezer only. Ensure
the Blending Head INJ 422VS is installed with
the Gear Cartridge INJ 321S (with screen) on
the frozen beverage freezer only. Mismatching
parts may result in poor product quality.
NOTE: Illustrations may only show soft serve
parts, freezers and fitments when instructions
also apply to frozen beverage parts, freezers
and fitments where noted.
NOTE:
Your hands should be cleaned and
sanitized before you perform these procedures.
NOTE: The procedures in this manual require
approved, serviceable and sanitized tools and
brushes. Contact your local distributor for
recommended supplies.
NOTE: Use an approved cleaner and sanitizer
for the procedures in this manual. Refer to
manufacturer’s instructions for proper
preparations of these cleaning agents.
NOTE: Inspect all wear items during
procedures and replace if necessary.
NOTE:
Consult your local distributor if you
have any questions concerning differences.
NOTE: If installing this unit on a frozen
carbonated beverage freezer, please refer to
the TS 80FCB operations manual for
instructions on installing, maintaining and
operating the FCB side components.
SAFETY PRECAUTIONS & PROCEDURE NOTES -- PLEASE READ!