35
Disassembling the Injector / Blending
Assembly
1. Rotate the Drive Motor to unlock and
remove the Drive Motor from the Drive
Assembly Gear Box.
2. Rotate the Injector / Blending Head to
unlock it from the Gear Box.
3. Remove the Gear Cartridge from the Gear
Box.
Sanitizing the Injector / Blending System
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Place the Drive Assembly Gear Box in
warm water and soak for at least 5 minutes.
Proceed with Steps 3 and 4 in the
meantime.
3. Brush and clean all exposed surfaces of the
Gear Cartridge with detergent water, then
rinse thoroughly.
4. Brush and clean all exposed surfaces of the
Injector / Blending Head with detergent
water, then rinse thoroughly. Use a small
brush to ensure that the syrup orifices are
clear of any residual syrup.
Summary of Contents for TS 44SS/BEV
